Website Banner

Web Links




CT Compression Molding Machine

CT Compression Molding Machine or CT hydraulic press, is for polymeric shaping in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, and heat and pressure are maintained until the molding material has cured in the case of rubber compound. The process employs thermosetting resins in a partially cured stage, either in the form of granules, putty-like masses, or preforms. CT Compression Molding Machine is a high-volume, high-pressure equipment suitable for molding complex, high-strength fiberglass reinforcements. Advanced composite thermoplastics can also be compression molded with unidirectional tapes, woven fabrics, randomly orientated fiber mat or chopped strand. The advantage of CT Compression Molding Machine is its ability to mold large, fairly intricate parts. CT Compression Molding Machine produces fewer knit lines and less fiber-length degradation than injection molding machine.
CT Compression Molding Process consists of hydraulic oil tank, hydraulic power unit, hydraulic pump, hydraulic control system, pressure switch, pressure guage, relief valve, hydraulic cylinder, control panel, temperature controller, mould, cavity mold, press lever, heating platen, and cooling platen.


CT Compression Molding Machine (Motor)

­ Pressure adjustment by electrical pressure

­ Electrical valves to control up-down directions of
    compression plate.
­ The hydraulic components are easily accessible
    for quick maintenance.

­ Safety door for user protection.
­ Safety valve for over-pressure protection.
­ Pressure releasing system in the case of
    electrical power failure.

 Pressure holding system to extend pressure
    pump life-time and to save energy.

 Automatic de-compression with setting timer.
 Automatic air repelling system is an optional.
 Cooling plate for rigidifying plastics is an optional.


CT Compression Molding Machine (Lever)

­ CT compression machine with the advanced

­ Suitable for plastic and/or rubber
 Two hydraulic pumping levers;
     High flow rate – low pressure lever and
     Low flow rate – high pressure lever 
­ Ability to hold pressure up to 2,800 psi
 Cooling plate for rigidifying plastics is an optional.
 Easy to control 
 Smooth running
­ Low cost
­ Long service life


Machine Catagory: Compression Molding Machine / Compression Moulding Machine / Hydraulic Press / Hydraulic Compression Machine / Plastic Compression Machine / Rubber Compression Machine
Current Pageid = 9